This kit includes: Flywheel, Flywheel Puller, Gasket and Generator Stator
All products shipped are tested

Heavy duty Magneto Flywheel rotor for Motorcycles.
Kimpex trade heavy-duty flywheel rotor for Kawasaki Motorcycles is a well-priced solution to problems with the OEM flywheel, and an excellent alternative to all the mechanical troubles you can encounter with a repair.

Built to OEM size: Fits precisely in your ride: install it and forget it.
Improved epoxy: Uses high temperature epoxy that is stronger than OEM, eliminating the possibility of magnet detachment.
High grade steel capping: Prevents harsh additives in motor oil from degrading the epoxy attaching
Precise balancing: Eliminates crankshaft vibrations for longer engine longevity.
Don't waste time with temporary solutions, and start fixing your ride like a pro!

WARNING FLYWHEEL!
OEM part no: 021003-1123 (GP9306) - Please check with your original rotor. The RMS120-104074 has 4 'protrusions' on the outside, 3 short and 1 long, (these trigger the pickup coil)

Our part is ONLY compatible with flywheels that have the following codes: FF95 & 1964K01

Flywheel Puller MP#18

18mm x 1.5 hand male
Includes crankshaft thread protector cap
Length: 30 mm
Exterior Diameter: 18 mm
Interior Diameter: 10.95 mm

Generator Stator

Direct replacement to your original unit
You must re-install your original grommet.
Once your connector and grommet is re-installed, our part becomes a Plug-and-play unit, direct fit, and very easy to install.
Highest grade lamination materials
Highest grade copper windings, resistant to 200 degrees Celsius.
Connector included

Battery condition is important. No stator can make up for a bad or weak battery. If in doubt charge your battery and have it load tested, or simply replace it. Always Start with a Fully Charged Battery!