Motorbike Engine Flush

Contents (250 mL) is sufficient for 3-4.5 liters (0.6 gal. to 1.2 gal.) oil. Add contents to warm motor oil before the oil change. After adding allow the engine to idle for 10 minutes, during the application pull in and hold clutch lever multiple times for a few seconds. Then drain the oil and change the filter.

Cleaning fluid for clearing the engine interior of troublesome deposits. Dissolves sludge and lacquer formers. All types of oil-soluble and oil-insoluble residues are brought into suspension and removed during the next oil change. An engine which has been cleaned of deposits and contamination and which is then filled with fresh oil not contaminated with old impurities can develop its full performance characteristics.

Density at 20°C : 0.815 g/cm³
Viscosity at 40°C: 22.58 mm²/s